Process industries - chemical processing, pharma intermediates, food & beverage and general manufacturing - depend on valve automation for dosing accuracy, line isolation and steam control across continuous runs.
We supply the automation package end to end: rotary or linear pneumatic actuators, the ball or butterfly valve body, the solenoid valve that pilots it, and the limit switch that confirms position back to the control room - sized as one matched system rather than components bought separately.
Where these get used
| Application area | Typical duty |
|---|---|
| Dosing & batching lines | Frequent on-off cycling, tight shut-off on air, water, oil, gas or chemicals |
| Isolation valves | Ball and butterfly valves with rotary actuators for remote on-off duty |
| Steam service | Control valves sized for saturated or superheated steam applications |
| Actuator feedback | Limit switch boxes for open/close position confirmation to the control room |
Products specified into this industry
Pneumatic Actuators
Rotary & linear actuators sized to torque, media and fail-safe duty.
View range
Solenoid & Directional Control Valves
Full 5/2 & 3/2 range - pilot-operated, direct-acting, hand-lever, poppet and Namur designs.
View range
Ball & Butterfly Valves
Manual and actuated - on-off & isolation duty, flanged or screwed.
View rangeSupplied to plants operated by
- Reliance
- Aditya Birla
- GSFC
- GNFC
- GIPCL
- UPL
- Wonder Cement
Company names and marks are shown to identify plants we have supplied. All trademarks belong to their respective owners; no endorsement or affiliation is implied.
Frequently asked
What determines whether a process valve needs a double-acting or spring-return actuator?
The fail-safe requirement. If the process must default to a safe on-off position on air-supply loss, a single-acting spring-return actuator is specified. If position doesn’t matter on air loss, double-acting is usually the more economical choice.
Can you match an existing installed actuator brand?
Yes - send the nameplate details or a photo and we’ll match on ISO 5211 mounting, torque and port pattern, either genuine or a matched equivalent.
Have a spec for this application?
Send it over - we size to torque, media and fail-safe duty, and target a quote inside 24 hours.